White Cap is right. The last step in instillation is to correctly position the servo motor wheel. There's a small screw which holds it down on top of a splined shaft. You remove the screw & gently pry up the wheel. Position the wheel so the rod to the throttle is closest to the carb. & replace the screw. That way the rotation of the wheel gives immediate response.
I took the control king & my motor into my shop and worked on it there. I used a battery jumper pack for juice and played with it a bit until I got it right. When the motor & CK were on the sawhorse I could see exactly how it worked & easily position the wheel. When I put the motor on "The Tank" it worked perfectly. If you have any problems call the guy at Magma Mfg. He was very helpful.
Thanks for the input!!!!
My boat is in the lake at the dock so it sounds like I need to take it off and bring it home to the workshop for a good clean instalation. I was going to do it on the boat but now after hearing these few responses I will remove and install in a dry shop.
thanks guys I will post how it came out and if I am happy with it I am sure I will be.
