I purchased two mag 10 downriggers that are about 5 yrs old and have a few questions about them. The first is about the mounting base. I bought two new bases that are a solid block of plastic about 4 x 4 inches. There seems to be some slop when the rigged is mounted. If I hit a wave it will rock back and forth even if the weight is in the water. Is this normal? The other question is about the ion control. The motor seems to be making a noise very similar to the wine u get from the cable. This occurs only when the cable is in the water while I am trolling not when the motor is operating. I wonder if it is the part that creates the ion charge. Any thoughts?
I through bolted the base plate to the gunnel with a backer plate behind them. The mounting plate itself is solid but the connection between the rigger and base plate is where the slop seems to be. Even if I tighten down the knob to the base plate as tight as it will go it seems to make no difference.
Sounds like you did everything right. Try loosning the knob all the way and make sure the rigger is all the way foward and retighten. I don't know what else to tell you.
To your first question, I don't get any slop when my Cannon rigger is screwed down tight. I use the same base that I believe you are using. My base is connected to a traxstech swivel base, which is seated to a track, so maybe that's why I don't get that slop. Not sure?
The noise you are hearing is normal. That's the positive ion control working. You'll notice it gets louder when the wind picks up. It can be annoying I know.
Mine aren't seated to a track and there is a little play. I have four mag 10's and I never noticed it until you mentioned yours. One had a loose knob today and I tightened it and there was no play. The rest were tight but still a little play. Probably just a normal thing.
